News

How to install mobile DVR / MDVR and Vehicle Cameras on Bus, Truck, tanker, tow vehicles, trailers, cars

As more and more rider are installing four channel driving recorders. This article was made for the convenience of the people who can also install the recorder by themselves, saving installation cost. We hope to help more car friends and that the four-track driving recorder will bring you driving convenience and driving safety protection.



Mobile vr for vehicles installationools / traw materials


One digital high-definition 720P / 1080P host

One HD interface display

Four Cameras

Memory card or hard disk

Several video extension cables



Mobile DVR for vehicles installation method / step 1:


Check the configuration and understand the composition of the system.
mobile dvr



Mobile dvr for vehicles installation method / step 2:


Consider the installation position of main engine, monitor and camera

1.main engine Installation: In the Front passenger side baffle; storage box above the front windshield; storage box on the instrument panel; Instrument Table; under the seat; under the berth or on the left and right side walls(Reference images are below)

2.Mounting position of the monitor : The desktop monitor is fixed on the instrument table, and it is hung on the front glass ; the ceiling monitor is directly mounted on the ceiling (Reference images are below)


3.Camera installation :  according to the position of your personal requirement (Reference images are below)


mobile dvr


Mobile dvr for vehicles installation method / step 3:

Install the mian engine , the size drawing of the main engine is as follows

If you want to shut down and record video (24 hours video), please connect the host red and yellow wire to the positive pole of the battery; black Tie; memory card machine a power consumption of about 20 watts, a hard disk machine a 15 watts or so, please pay attention to the battery capacity problem, the proposal to add a switch to prevent feeding.

If you need to start recording , please connect red power yellow ACC line and black ground ( can be set to delay shutdown. if the power is off, it will continue to record for a period of time.The time can be set ; there will be no power off at the moment of fire ) or connect red  ACC line and  black ground ( stop recording when power off )

After the main engine and the power cord are ready, make sure that the positive and negative poles of the power cord is not wrong and plug into the power supply.


The PWR lamp will be lit up, followed by other lights will be lit up or flashing

Now you can plug in the Monitor and the camera to see the initial results
mobile dvr


mobile dvr

mobile dvr


Mobile dvr for vehicles installation method  / step 4:


Consider the camera position as a whole, especially the left and right camera positions and fix it.
After the normal display, we can determine the camera installation position nad make a mark.Fix the camera.
 mobile dvr
mobile dvr


mobile dvr


Mobile dvr for vehicles installation method / step 5:

Front view camera trace:

1.The ball front view camera is fixed to the instrument panel : the alignment is relatively simple, no explanation

2.The ball front view camera is fixed to the ceiling and moves down the right side a pillar through the curtain rail to the main engine

3. The outdoor square camera is fixed below the front rain gear or above the rain gear plastic, and the wire is routed to the right side of the rain gear -the right A pillar is down - towards the host

Note : For a better concealed harness, the wire can be tucked into the curtain rails, into the a pillar cover and strip of tape. If you're buying a ceiling monitor, install the monitor first, then go with the camera line


mobile dvr


Mobile dvr for vehicles installation method/ step 6:

Rear view camera trace

1 , bicycle : from back to front, along the line of the rear lights of the bicycle.

2.Trailer : Two lines are often provided, one for the carriage part and the other for the front part, so that they can be easily picked and hung. The carriage part is arranged from the back to the front, along the wire of the real lights. The front part goes all along the way along the spiral or down the beam.

Open the hood and look for holes in the car. Check the position of the original harness into the vehicle; check if there are any existing holes;

If you want to connect the reverse trigger wire, please draw a power cord from the positive pole or the reverse switch of the reverse lamp, go to the main engine with the extension cord of the rear camera, and connect the reverse trigger wire of the main engine

Note :

Male and female heads of the video cable, do not pull back ( just pull the female head forward )

do not pull back of the video line connector of the male and female (just to pull the female head forward)

Video cable on the headline trace avoid temperature location

Please gently pull the video cable


mobile dvr



Mobile dvr for vehicles installation method / step 7:

Left and right camera trace

Left and right cameras are generally mounted in the left and right rear view mirrors, as shown in the following illustration or video alignment

1 , the more common wiring diagram, the video is as follows

2 , as shown below, open the rear view mirror, there are holes in it to thread

mobile dvr



Mobile dvr for vehicles installation method  / step 8:

Fixed display and organize line
mobile dvr


The desktop display is directly fixed on the workbench or in other ways, as shown in figure

Mobile dvr for vehicles installation method / step 9:

The installation and diagram of the ceiling display are as follows :
mobile dvr




Mobile dvr for vehicles installation method / step 10:

This is what the final image looks like, or it can be attached to the car

If you have other questions please click Resources for more information.
 mobile dvr


mobile dvr

mobile dvr

mobile dvr


Note

No lights on the main engine-check the power connection is correct; check the power line fuse is broken; equipment failure

The main engine only has PWR lights ---Check the keys for locks; check the Yellow Power Cord for power

Mobile dvr for vehicles installation

The main engine lamp is normal, the Monitor has electricity, does not display the picture -- switches the monitor Av key to VGA mode; checks the video cable connection also consider whether the length of each extension line is sufficient


No previous No next

CONTACT US

Contact: Nick Huang

Phone: +86 18998078488

Tel: +86-769-81001848

Email: nick@eastyletech.com

Whatsapp:+8613265680731

Add: 705 Juyue Dianshang Building, Tangxia Town, Dongguan,Guangdong, CN